Exergy analysis of the sugar production process from sugar beets

Author(s):  
T. Tekin ◽  
M. Bayramoğlu
Author(s):  
Lubov Belyaeva ◽  
Michail Pruzhin ◽  
Alla Ostapenko ◽  
Valentina Gurova

Introduction. Technological aids play a special role in sugar production technology, but their complex effectiveness requires a comprehensive and in-depth study. The research objective was to establish the patterns of change in the technological indicators of semi-finished products obtained from bacterially infected sugar beets with the combined use of an enzyme preparation, antimicrobial agent, and defoamer. Study objects and methods. The study involved such semi-finished products as juice (diffusion, pre-defecated, first and second saturation) and syrup, the quality of which was determined according to standard methods. The laboratory experiment was carried out on the basis of the second-order D-optimal Box-Behnken plan for three factors at three levels. Results and discussion. The research revealed positive dynamics of the following technological indicators: sucrose content, deposition rate, turbidity, chromaticity, and general purification effect. The sugar beet had the second degree of infection with mucous bacteriosis. Purified juice underwent lime-carbon dioxide purification and thickening under the combination of enzyme preparation Dextrasept 2, antimicrobial agent Betasept, and antifoam agent Voltes FSS 93. The greatest increase in sucrose at the level of 1.1% by DM weight was confirmed by a higher overall effect of purification of diffusion juice (2.2 %). The values of turbidity of the purified juice and syrup were below the threshold values. The low values resulted from the increase in the sedimentation rate of the pre-defective juice and the juice of the first saturation by an average of 4.1 and 3.2 times, respectively, due to the effective removal of high molecular weight compounds. The share of the enzyme preparation was 40–71%, antimicrobial agent – 19–49%, defoamer – 1.6–6.5%. The values of the multicriteria optimization parameter corresponded with technological indicators. The optimal combination (per 1000 tons of beets) included 6–8 kg of Dextrasept 2, 1.5–2.0 kg of Betasept, and 15–20 kg of Voltes FSS 93. As a result, the yield of white sugar increased by 0.25%. Conclusion. The regression dependencies can be recommended for predicting the main technological indicators of semi-finished products. The resulting data makes it possible to determine the effectiveness of the combined use of an enzyme preparation, antimicrobial agent, and defoamer in sugar production. Further research will identify the patterns of multifactorial interaction of these preparations.


2022 ◽  
Vol 226 ◽  
pp. 107070
Author(s):  
Shuo Ma ◽  
Shilei Lu ◽  
Hongting Ma ◽  
Renxi Li ◽  
Chang Xu ◽  
...  

2015 ◽  
Vol 182 ◽  
pp. 258-266 ◽  
Author(s):  
Jeehoon Han ◽  
Jeremy S. Luterbacher ◽  
David Martin Alonso ◽  
James A. Dumesic ◽  
Christos T. Maravelias

2017 ◽  
Vol 16 (1) ◽  
Author(s):  
Mila Faila Sufa ◽  
Umi Khoiriyah

<span class="fontstyle0">A company should pay attention to operational risk to maximise its efficiency and effectivity.<br />Identification of failure and the cause and the impact of the failure at milling station is needed to be done so that the sugar production process can run well. Here, we employ a failure mode and effect analysis to identify the failure and its effect. We obtain 22 operational risks with two critical risks. The two critical risks are then used as top event in analysing the cause of the failure. The result from fault tree analysis shows that there are 4 basic events, which are the turbine vibrates, schedule part’s change before failure, high rainfall and the schedule and priority of processing</span>


Author(s):  
Kariana Moreno Sader ◽  
Jeffrey León Pulido ◽  
Ángel González-Delgado

Palm production chains in Colombia have some unsatisfied demands that affect their competitiveness. Specific demands include efficiency in energy use. Therefore, in the present report, an exergy analysis for the dual crude palm and kernel oil production process was carried out to determine the main energy sinks and suggest technological improvements that allow better use of energy. For this study, the process was initially simulated in the Aspen Plus ® software, where the chemical and physical exergies of the species and streams involved were quantified. The process irreversibilities, the exergy loss, the exergy of waste, and the exergy of utilities were calculated for each stage and the whole process. An overall exergy efficiency of 18% was achieved, while the highest process irreversibilities contribution was due to the destroyed exergy with the waste in the threshing stage. To increasing the global exergy efficiency of dual crude palm and kernel oil production, it is proposed the evaluation of palm rachis use to obtain biofuels and/or high-value products.


2018 ◽  
Vol 5 ◽  
pp. 15-21
Author(s):  
Nataliia Husiatynska ◽  
Tetiana Nechypor

The article presents the results of the studies of the effectiveness of disinfection means, based on chlorinated guanidines, tetradic ammonium salts, dichlorisocyanuric acid, peracetic acid and hydrogen peroxide as to the contaminating microflora of sugar beets. There was investigated the influence of disinfectants on bacteria Bacillus subtilis, Leuconostoс mesenteroides, mycelia fungi Aspergillus niger, Penicillium chrysogenum and yeast Sacharomyses сerevisiae. It was experimentally established, that the studied means has the high effectiveness as to most microorganisms that cause saccharose losses in the process of its extracting from beet chip and result in worsening a technological quality of semi-products of beet-sugar. There was established the high effectiveness of modern disinfection means as to inhibiting slime-forming bacteria of Leuconostoc generis. There was proved a possibility of their use at different technological stages of beet-sugar production for preventing the development of mucous bacteriosis. It was determined that means consumption depends on a type and extent of microbiological contamination of raw materials, semi-products, technological waters at sugar production. There were established concentrations of the studied means as to inhibiting the development of main contaminants of the microflora of raw materials and semi-products in sugar production. There is offered to use the studied means in industrial beet-sugar production that would favor the decrease of microbial contamination of semi-products and the increase of a sugar output from a raw material unit.


2018 ◽  
Vol 11 (14) ◽  
pp. 651-658
Author(s):  
Maria Sanjuan-Acosta ◽  
Kelly Ramos Romero ◽  
Manuel Gomez Ochoa ◽  
Eduardo Sanchez-Tuiran ◽  
Angel Dario Gonzalez-Delgado

Sign in / Sign up

Export Citation Format

Share Document